Skip to content

Configuration

Connect USB cable

Connect USB

Open the service lid and connect a USB-to-Micro-USB cable Connect the other end to a Windows PCs USB-Port. The RTL LED should start to blink.

Configure using PPX

PPX

While the device is connected to the PC open ppx.parametric.ch to access the online configuration tool. Follow the instructions on the screen to establish a connection.

Set Distance to Lanes

Once connected open Radar-Settings and find Left To Right Lane Distance and Right To Left Lane Distance

  • Enter LTRDist value you measured in #measure-distance-to-lanes) into the field LTRDist
  • Enter RTLDist value you measure in #measure-distance-to-lanes) into the field RTLDist
  • Press Save

PPX

Sensitivity

Turn on autotune to allow the radar to adjust the sensitivity.

After entering LTRDist and RTLDist the sensitivity is automatically determined based on those values. The further the distance to the measurement, the higher the sensitivity.

Note: Small adjustments of sensitivity can be done manually. If the ratio (sensitivity vs. RTL/LTR) is not correct, the radar may incorrectly categorize the measured object.

PPX